Sunbeam Hot Beverage Maker KE2100 User Manual

Express Kettle  
Instruction Booklet  
This book covers the use and care of the following Sunbeam Kettles:  
KE2100 Express – Corded Automatic Kettle  
KE4400 Express Filter – Cordless Automatic Kettle  
Please read these instructions carefully  
and retain for future reference.  
 
Sunbeam’s Safety Precautions  
SAFETY PRECAUTIONS FOR YOUR  
KETTLE.  
• Boiling water will scald. Do not leave a  
boiling or hot kettle near or where children  
may touch it.  
• Do not operate the kettle without water.  
• Do not operate the kettle unless the element  
is fully immersed in water or filled to the  
minimum level indicated.  
• NOTE: If the kettle is overfilled and tilted  
backwards, water may leak from the control  
area. This is normal for this kettle design,  
and will not damage the kettle in any way.  
• Boiling water maybe ejected, if overfilled.  
• Do not leave the power cord near the edge of  
a bench top where children may touch or  
pull it.  
• Your Express kettle must only be used with  
the Power Base supplied.  
• Do not move kettle while switched on.  
• Always operate the kettle on a flat, level  
surface.  
• Always switch the power off and unplug the  
cord while the kettle is NOT in use.  
Important instructions – retain for  
future use.  
If you have any concerns regarding the performance and use of your appliance,  
Ensure the above safety precautions are understood.  
2
 
Sunbeam’s Safety Precautions  
Sunbeam are very safety conscious when  
• Do not use an appliance for any purpose  
other than its intended use.  
• Do not place an appliance on or near a hot gas  
flame, electric element or on a heated oven.  
Do not place on top of any other appliance.  
• Do not let the power cord of an appliance hang  
over the edge of a table or bench top or touch  
any hot surface.  
designing and manufacturing consumer products,  
but it is essential that the product user also  
exercise care when using an electrical appliance.  
Listed below are precautions which are essential  
for the safe use of an electrical appliance:  
• Read carefully and save all the instructions  
provided with an appliance.  
• Always turn the power off at the power outlet  
before you insert or remove a plug. Remove  
by grasping the plug - do not pull on the cord.  
Turn the power off and remove the plug  
when the appliance is not in use and  
before cleaning.  
• For safety reasons and to avoid maintenance  
by unskilled persons, some appliances are  
‘sealed’ using tamperproof screws. Such  
appliances should always be returned to the  
nearest Sunbeam Appointed Service Centre  
for adjustment or repair if required.  
• Do not use your appliance with an extension  
cord unless this cord has been checked  
and tested by a qualified technician or  
service person.  
• Always use your appliance from a power  
outlet of the voltage (A.C. only) marked  
on the appliance.  
• Close supervision is necessary when your  
appliance is being used near children or  
infirm persons.  
• Never leave an appliance unattended while  
in use.  
• Do not operate any electrical appliance with a  
damaged cord or after the appliance has been  
dropped or damaged in any manner. If damage  
is suspected, return the appliance to the  
nearest Sunbeam Appointed Service Centre  
for examination, repair or adjustment.  
• For additional protection, Sunbeam  
recommend the use of a residual current  
device (RCD) with a tripping current not  
exceeding 30mA in the electrical circuit  
supplying power to your appliances.  
• Do not immerse the appliance in water  
or any other liquid unless recommended.  
• Young children should be supervised to ensure  
that they do not play with the appliance.  
3
 
Features of your Express Kettle  
– KE2100  
1.8 litre capacity.  
For up to 10 cups of water.  
Robust one-piece design.  
Safe, fully enclosed one-piece design. Minimises  
spillage if the kettle is dropped as there is no lid to  
pop open.  
Full length water gauge.  
Indicates the amount of water in the kettle.  
2400 watt element.  
The fast boil 2400 watt element boils  
2 cups of water in approximately one minute.  
3-Way Safety System.  
1 - Automatically switches the kettle  
off after boiling.  
2 - Cuts out for boil-dry protection.  
3 - Shuts down in case of overheating.  
4
 
Ergonomic.  
The handle provides greater pouring balance  
and prevents steam burns when pouring.  
On/Off switch with auto cut-out.  
Automatically switches the kettle off after  
boiling.  
Removable cord.  
Makes the kettle easy to fill at the sink and  
easy to pour.  
5
 
Features of your  
Express Filter Kettle – KE4400  
Robust one-piece design.  
Safe, fully enclosed one-piece design. Minimises  
spillage if the kettle is dropped as there is no lid  
to pop open.  
Removable mesh filter.  
Eliminates water scale deposits for cleaner water.  
1.8 litre capacity.  
For up to 10 cups of water.  
Full length water gauge.  
Indicates the amount of water in the kettle.  
2400 watt element.  
The fast boil 2400 watt element boils  
2 cups of water in approximately one minute.  
3-Way Safety System.  
1 - Automatically switches the kettle  
off after boiling.  
2 - Cuts out for boil-dry protection.  
3 - Shuts down in case of overheating.  
6
 
3 cord exits  
Cord storage cavity  
Cord winds neatly under the  
base for safe, convenient  
storage.  
Ergonomic.  
The handle provides greater pouring balance  
and prevents steam burns when pouring.  
On/Off boil switch with auto cut-out.  
Automatically switches the kettle off after  
boiling.  
Power base.  
Cordless for greater convenience. The power  
base also features a cord storage cavity  
underneath and 3 cord exits.  
Rubber feet.  
Non-slip rubber feet.  
7
 
Using your Express Kettle  
Before using your kettle.  
4.Lift the kettle from the power base and  
pour the water.  
It is recommended that you clean your  
kettle before use by boiling a full kettle of  
water then discarding the water.  
NOTE: Use caution when pouring the water  
from your kettle, as boiling water will  
scald.  
Using your kettle  
5.The kettle may be stored on the power  
base when not in use. The kettle will not  
re-boil until the ON/OFF switch is pressed  
downward.  
NOTE: Ensure the power is turned OFF at  
the power outlet while the kettle is not in  
use.  
Should you accidentally allow the kettle to  
operate without water, the boil-dry  
protection will automatically switch it off.  
If this should occur, allow the kettle to  
cool before filling with cold water and re-  
boiling.  
1.To fill the kettle, remove it from the power  
base and fill with the desired amount of  
water.  
Always fill the kettle between the minimum  
and maximum marks. Too little water will  
result in the kettle switching off before the  
water has boiled. Too much water may  
cause it to spill out of the spout when  
boiling.  
2.Connect the plug into a 230-240 Volt AC  
power outlet. Turn the power ON.  
3.Position the kettle on the power base.  
Press the ON/OFF button. The kettle will  
switch off automatically once the water has  
boiled.  
Cord Storage Facility  
Excess cord can be stored by feeding the  
cord into the storage cavity underneath the  
power base.  
NOTE: Ensure that the ON/OFF switch is  
clear of obstructions. The kettle will not  
turn off if the switch is constrained. Do not  
remove the (KE4400) from the power base  
while in use.  
8
 
Sunbeam’s 3 Way  
Safety System  
Safety is a major consideration in the  
design of a Sunbeam kettle. This is why we  
have developed our 3-Way Safety System,  
which ensures that your kettle will:  
3. Shut-down in case of overheating.  
In the event of overheating, the kettle will  
automatically shut down to prevent further  
damage. Should this occur, take your kettle  
to a Sunbeam Service Centre or Appointed  
Service Agent.  
1. Automatically switch off after boiling.  
For convenience, safety and energy  
efficiency, your Sunbeam kettle features an  
auto cut-out device.  
2. Cut-out for boil-dry protection.  
If the kettle is operated without water, it  
will automatically cut-out, preventing any  
damage to the element.  
9
 
Care and Cleaning  
Always remove the plug from the power  
outlet before cleaning.  
Never immerse the kettle switch area or  
cord in water, or allow moisture to come  
into contact with these parts.  
2.Empty the solution from the kettle. Any  
stains remaining inside the spout can be  
removed by rubbing with a damp cloth. Fill  
the kettle with clean water, bring to boil  
and then discard the water. Repeat and the  
kettle will then be ready to use.  
The outside of the kettle can be wiped over  
with a damp cloth.  
CAUTION: Do not use chemical, steel wool, or  
abrasive cleaners to clean the outside of the  
kettle.  
Removal of mineral deposits.  
Mineral deposits in tap water may cause  
the kettle interior to discolour. To remove  
this build-up, use Sunbeam Liquid  
Descaler, a simple to use, non-toxic  
cleaner available from Sunbeam Appointed  
Service Centres.  
Alternatively:  
1.Fill the kettle with 3 cups of white vinegar  
and the remainder with water and allow to  
stand overnight. DO NOT BOIL.  
10  
 
Consumer Hotline  
Australia  
1800 025 059  
New Zealand  
(09) 912 0747  
Consumer information:  
is a registered Trademark of Sunbeam  
Corporation Limited. ACN 000 006 771.  
© Sunbeam Corporation Limited 2003.  
 

Shark Carpet Cleaner S3305 User Manual
Sharp Microwave Oven R 21 FBST User Manual
Sony Camcorder BRC 300 User Manual
Sony Camera Accessories AC UP100 User Manual
Sony Cassette Player TCM 200DV 150 User Manual
Sony Projection Television KV 30HS510 User Manual
Spalding Fitness Equipment 21173402 User Manual
Stanton CD Player S 650 MK II User Manual
Sybase Model Vehicle DC00297 01 0670 01 User Manual
Sylvania DVD Player DP140SL8 User Manual